Skip to main content

Water Well Drilling in Addy, WA

Addy sits on the Colville River between Chewelah and Colville, about 48 miles from our base in Reardan. Water is fairly close to the surface here, but wells produce less of it than anywhere else in Stevens County, and newer wells have gone deeper. Here's what the state's records show.

Simplified drawing of the ground and a typical well Ground around Addy: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 200 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 200 ft Half of wells 110–340 ft Water fills to 43 ft Water fills to Unknown
A typical well around Addy It's 200 ft deep. Water fills the well up to about 43 ft below the ground (the blue). Half the wells here are 110 to 340 ft deep, shown by the bracket. Based on state well records.

Well data for Addy

From 245 water well reports filed with the Washington State Department of Ecology.

Median well depth
200 ft
Half are 110–340 ft deep
Water well reports
245
21 drilled since 2020
Median depth to water
43 ft
Static water level at completion
Median well yield
4 gpm
Gallons per minute at completion
How deep wells run around Addy
  • Under 100 ft 22% of wells (50)
  • 100–199 ft 27% of wells (61)
  • 200–299 ft 16% of wells (35)
  • 300–399 ft 16% of wells (36)
  • 400–599 ft 15% of wells (34)
  • 600 ft or more 4% of wells (9)

Wells drilled since 2015 have a median depth of 260 ft, deeper than the 164 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Addy than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (39 reports list a water level and 40 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Wells Around Addy

The state has 245 water well reports for the area around Addy, a smaller record than around the bigger valley towns, and 21 of them are for wells drilled since 2020. The median well is 200 feet deep, close to the Stevens County median of 194 feet, with half of the wells between 110 and 340 feet and one in ten past 500 feet.

Water typically settles about 43 feet below the surface once a well is drilled, shallower than the county's 60 feet. Yields are the catch: the median tested yield is 4 gallons per minute, the lowest of any Stevens County community we track, against 7 for the county.

Where New Wells Are Going

Most of the well reports, recent and older, are west, northwest and north of town. Since 2015, 29 of the 35 reports have been west or northwest of town. The medians there are 185 feet to the west and 212 feet to the northwest, and 177 feet to the north. Newer wells have gone deeper overall, and the reports filed for the properties closest to yours are the best guide to what yours will need.

Thick Clay Under the Valley

The U.S. Geological Survey's study of the Colville River watershed found a layer of lake-bed clay and silt under the valley floor that averages about 150 feet thick, and its greatest recorded thickness, more than 400 feet, is in areas near Addy and Kettle Falls. Beneath that clay is a lower sand and gravel aquifer, confined in most of the valley (USGS SIR 2004-5237). On the valley floor, that means a well may pass through a lot of clay before it reaches water-bearing sand and gravel.

The Colville Watershed Rules

Addy is in the Colville River watershed (WRIA 59). Under the 2018 streamflow law, a new home on a new permit-exempt well is limited to an annual average of 3,000 gallons a day, with no more than 5,000 on any day, and Stevens County collects a $500 fee with the building permit (RCW 90.94.020).

Water for bigger uses is scarce. Ecology says the Colville River is closed to new uses from July 16 to September 30 each year, that the watershed's tributaries are "generally closed to new water uses," and that new groundwater appropriations are subject to the same conditions; the 2018 law is what allows a new home's permit-exempt well despite those closures (Ecology's WRIA 59 summary). For irrigation beyond a household's lawn and garden, plan on talking with Ecology before you drill.

What Stevens County Needs Before You Build

The county's guide to potable water requirements asks for at least 800 gallons a day for a single home, held over four hours, and lab results less than two years old from a state-certified lab showing no coliform bacteria and nitrate, arsenic, lead and uranium within limits. If a well falls short on quantity, the county can approve storage, which matters where yields run as low as they do around Addy. The Northeast Tri-County Health District recommends re-testing for uranium every three to five years (NETCHD).

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Addy half of the wells land between 110 and 340 feet, with newer wells trending deeper. Our guide to the cost of drilling a well covers the rest. We also drill around Chewelah, about 8 miles away, and Colville. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Addy

How deep are wells around Addy?
What if my well near Addy is slow?
Is there a $500 fee for a new well near Addy?
How soon can you drill a well near Addy?