Skip to main content

Water Well Drilling in Clayton, WA

Clayton sits in southern Stevens County, a few miles from the Spokane County line and Deer Park. It's had more new wells since 2020 than any other community in Stevens County. Here's what the state's records show, and why which side of the county line you're on matters.

Simplified drawing of the ground and a typical well Ground around Clayton: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 160 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 160 ft Half of wells 100–265 ft Water fills to 35 ft Water fills to Unknown
A typical well around Clayton It's 160 ft deep. Water fills the well up to about 35 ft below the ground (the blue). Half the wells here are 100 to 265 ft deep, shown by the bracket. Based on state well records.

Well data for Clayton

From 899 water well reports filed with the Washington State Department of Ecology.

Median well depth
160 ft
Half are 100–265 ft deep
Water well reports
899
126 drilled since 2020
Median depth to water
35 ft
Static water level at completion
Median well yield
6 gpm
Gallons per minute at completion
How deep wells run around Clayton
  • Under 100 ft 25% of wells (213)
  • 100–199 ft 35% of wells (296)
  • 200–299 ft 18% of wells (157)
  • 300–399 ft 10% of wells (84)
  • 400–599 ft 9% of wells (81)
  • 600 ft or more 3% of wells (22)

Wells drilled since 2015 have a median depth of 220 ft, deeper than the 140 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Clayton than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (173 reports list a water level and 193 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

The Busiest Area for New Wells in Stevens County

The state has 899 water well reports for the area around Clayton, and 126 of them are for wells drilled since 2020, more than around any other Stevens County community we track. The median well is 160 feet deep. Water sits close to the surface, typically settling about 35 feet down, the shallowest of any community in the county, but the median tested yield is just 6 gallons per minute.

Where the New Wells Are

Much of the recent drilling has been northeast of town: 74 of the 191 well reports filed since 2015. Wells drilled there since then have a median depth of 300 feet and a median tested yield of only 3 gallons per minute. Elsewhere, wells are shallower: the median is 125 feet south of town, 146 feet to the southwest and 170 feet to the east, where the median yield is 13 gallons per minute.

Those are area medians, and neighboring properties can differ a lot. Before we give you an estimate, we look up the well reports filed for the properties closest to yours, including what those wells produced.

Two Counties, Two Sets of Requirements

Because Clayton is close to the county line, the wells grouped with it in the state's records come from both sides: 584 in Stevens County and 315 across the line in Spokane County, toward Deer Park. What you need for a building permit depends on which county your property is in:

  • Stevens County: Land Services' guide to potable water requirements asks for at least 800 gallons a day for a single home, held over four hours, and results less than two years old from a state-certified lab showing no coliform bacteria and nitrate, arsenic, lead and uranium within limits. The county can approve storage for a well that's short on quantity.
  • Spokane County: the Spokane Regional Health District reviews the well report, a pump test certification showing at least 1,440 gallons per day (one gallon per minute), and samples taken by an SRHD-approved sampler showing no coliform bacteria and nitrate no higher than 10 mg/L (SRHD water adequacy guide).

With yields as low as they run northeast of town, the quantity test is worth knowing about before you drill, and the nearby well reports tell us what to expect.

The Same Watershed Rule on Both Sides

Unlike the permit requirements, the water rule doesn't change at the county line. The whole Clayton area is in the Little Spokane watershed (WRIA 55), where a new home on a new permit-exempt well is limited to an annual average of 3,000 gallons a day, with no more than 5,000 on any day, and the county issuing the building permit collects a $500 fee (RCW 90.94.020). Wells drilled before January 19, 2018 aren't affected.

Testing Your Water

Coliform bacteria and nitrate come first on either side of the line. Uranium is the other one to watch: the Northeast Tri-County Health District says it "is especially common throughout Ferry, Stevens and Pend Oreille Counties" and recommends testing for it every three to five years (NETCHD). If a test turns something up, we're happy to recommend local water treatment professionals.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Clayton the median runs from 125 feet south of town to 300 feet for recent wells to the northeast. Our guide to the cost of drilling a well covers the rest. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Clayton

How deep are wells around Clayton?
Which county's well requirements apply around Clayton?
Why do newer wells around Clayton go deeper?
How soon can you drill a well near Clayton?