Skip to main content

Water Well Drilling in Springdale, WA

Springdale sits at the south end of the Colville River valley in Stevens County, about 28 miles from our base in Reardan. Wells here are some of the shallowest in the county, and the area around town straddles a watershed line, so the rules for a new well depend on which side you're on.

Simplified drawing of the ground and a typical well Ground around Springdale: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 149 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 149 ft Half of wells 87–242 ft Water fills to 71 ft Water fills to Unknown
A typical well around Springdale It's 149 ft deep. Water fills the well up to about 71 ft below the ground (the blue). Half the wells here are 87 to 242 ft deep, shown by the bracket. Based on state well records.

Well data for Springdale

From 780 water well reports filed with the Washington State Department of Ecology.

Median well depth
149 ft
Half are 87–242 ft deep
Water well reports
780
104 drilled since 2020
Median depth to water
71 ft
Static water level at completion
Median well yield
10 gpm
Gallons per minute at completion
How deep wells run around Springdale
  • Under 100 ft 30% of wells (223)
  • 100–199 ft 36% of wells (268)
  • 200–299 ft 16% of wells (120)
  • 300–399 ft 11% of wells (80)
  • 400–599 ft 6% of wells (49)
  • 600 ft or more 2% of wells (14)

Wells drilled since 2015 have a median depth of 166 ft, deeper than the 140 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Springdale than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (154 reports list a water level and 172 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Wells Around Springdale

The state has 780 water well reports for the area around Springdale, and 104 of them are for wells drilled since 2020, among the most in Stevens County. The median well is 149 feet deep, one of the shallowest medians in the county, and half of the wells are between 87 and 242 feet. Water typically settles about 71 feet below the surface, and the median tested yield is 10 gallons per minute.

West of town the median is 135 feet and to the south 115 feet, and that's where much of the recent drilling has been: 84 of the 168 reports filed since 2015. To the north and northeast, wells run deeper, with medians of 224 and 220 feet. Before we give you an estimate, we look up the well reports filed for the properties closest to yours.

At the Head of the Colville Valley

During the last ice age, a lobe of glacial ice filled the Colville valley, and the U.S. Geological Survey's study of the watershed marks its southern limit with "a well-developed terminal moraine, the Springdale moraine." Under the valley floor, a lower sand and gravel aquifer runs north from here toward Kettle Falls. Its water levels are highest near Springdale, USGS reports that it's recharged from the south end of the watershed, and downstream of the Springdale area many wells completed in it flow at the land surface (USGS SIR 2004-5237).

Two Watersheds, Two Sets of Rules

The area around Springdale straddles the divide between two watersheds, and the rules for a new home's well differ between them:

  • Lower Spokane watershed (WRIA 54): about 63% of the well reports, with a median depth of 140 feet. The standard permit exemption applies: up to 5,000 gallons a day for household use, plus watering up to half an acre of lawn or noncommercial garden, without a water right (RCW 90.44.050), and no streamflow fee.
  • Colville River watershed (WRIA 59): about 37%, with a median of 160 feet. A new home on a new permit-exempt well is limited to an annual average of 3,000 gallons a day, with no more than 5,000 on any day, and the county collects a $500 fee with the building permit (RCW 90.94.020).

Watershed lines don't follow roads or parcel lines, so Stevens County confirms which rule applies to your parcel when you apply for the building permit. Wells drilled before January 19, 2018 aren't affected by the Colville watershed limit.

What Stevens County Needs Before You Build

Stevens County Land Services' guide to potable water requirements asks for at least 800 gallons a day for a single home, held over four hours, and lab results less than two years old from a state-certified lab showing no coliform bacteria and nitrate, arsenic, lead and uranium within limits. The county can approve storage if a well is short on quantity, or treatment with a recorded notice if it's short on quality. The Northeast Tri-County Health District recommends re-testing for uranium every three to five years, since it "is especially common throughout Ferry, Stevens and Pend Oreille Counties" (NETCHD).

Planning Your Budget

Depth is the biggest factor in what a well costs, and Springdale's shallower wells help: half of them land between 87 and 242 feet. Our guide to the cost of drilling a well covers the rest. We also drill around Loon Lake, about 5 miles away. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Springdale

How deep are wells around Springdale?
Does the $500 fee apply to a new home near Springdale?
What's under the ground around Springdale?
How soon can you drill a well near Springdale?