Skip to main content

Water Well Drilling in Valleyford, WA

Valleyford sits south of Spokane Valley in the Hangman Creek watershed, about 31 miles from our base in Reardan. It's one of the busier areas for wells in Spokane County, and depths change a lot depending on which side of town you're on. Here's what the state's records show.

Simplified drawing of the ground and a typical well Ground around Valleyford: The ground changes across the area: sediment in some places, rock close to the surface in others. A typical well reaches 225 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 225 ft Half of wells 150–360 ft Water fills to 90 ft Water fills to Unknown
A typical well around Valleyford It's 225 ft deep. Water fills the well up to about 90 ft below the ground (the blue). Half the wells here are 150 to 360 ft deep, shown by the bracket. Based on state well records.

Well data for Valleyford

From 1,099 water well reports filed with the Washington State Department of Ecology.

Median well depth
225 ft
Half are 150–360 ft deep
Water well reports
1,099
71 drilled since 2020
Median depth to water
90 ft
Static water level at completion
Median well yield
17 gpm
Gallons per minute at completion
How deep wells run around Valleyford
  • Under 100 ft 6% of wells (67)
  • 100–199 ft 34% of wells (362)
  • 200–299 ft 24% of wells (258)
  • 300–399 ft 15% of wells (167)
  • 400–599 ft 15% of wells (167)
  • 600 ft or more 5% of wells (57)

Wells drilled since 2015 have a median depth of 260 ft, deeper than the 200 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Valleyford than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (136 reports list a water level and 172 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Wells Around Valleyford

The state has 1,099 water well reports for the area around Valleyford, and 71 of them are for wells drilled since 2020. The median well is 225 feet deep, half of the wells are between 150 and 360 feet, and one in ten goes deeper than 500 feet. Water typically settles about 90 feet below the surface, and the median tested yield is 17 gallons per minute.

Most Wells Are West and Northwest of Town

About 77% of the well reports are west and northwest of town. Northwest of town the median well is 250 feet deep, with water about 80 feet down and a median yield of 20 gallons per minute. West of town the median is 231 feet, with water about 100 feet down and a median yield of 12 gallons per minute, and wells drilled there since 2015 have a median of 300 feet. Southwest of town the median is 246 feet.

East and south of town, far fewer wells have been drilled, and they're shallower: medians of 160 and 172 feet. Most of the recent drilling has stayed west and northwest, 103 of the 155 reports filed since 2015. Before we give you an estimate, we look up the well reports filed for the properties closest to yours.

The Hangman Creek Watershed

Valleyford is in the Hangman Creek watershed (WRIA 56), which isn't covered by the 2018 streamflow law's fee and 3,000-gallon limit. A household well can supply up to 5,000 gallons a day, plus watering up to half an acre of lawn or noncommercial garden, without a water right (RCW 90.44.050).

Ecology describes a watershed where water is tight. Precipitation ranges from 17 inches a year around Spokane to 25 inches in the higher country to the east; in summer, streams depend on groundwater; the availability and yield of groundwater from bedrock is "very limited"; and "many areas are in decline, meaning little if any water is available for new consumptive appropriations" (Ecology's WRIA 56 summary). That matters most for larger uses that need a water right.

Building Permit Water Requirements

Before a building permit is issued for a home on a private well in Spokane County, the Spokane Regional Health District reviews water adequacy: the well report, a pump test certification showing at least 1,440 gallons per day, and samples taken by an SRHD-approved sampler showing no coliform bacteria and nitrate no higher than 10 mg/L (SRHD water adequacy guide). We file the well report with Ecology within 30 days of finishing. How to read a well report.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Valleyford the median runs from 160 feet east of town to 250 feet northwest of town, with some wells far deeper. Our guide to the cost of drilling a well covers the rest. We also drill around Mica, about 2 miles away, and Spokane Valley. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Valleyford

How deep are wells around Valleyford?
Do wells differ from one side of Valleyford to the other?
Is there a $500 fee or 3,000-gallon limit for a new well near Valleyford?
How soon can you drill a well near Valleyford?