Skip to main content

Water Well Drilling in Colbert, WA

Colbert sits in the Little Spokane River valley north of Spokane, between Mead and Chattaroy. Most of the wells here were drilled decades ago, so whether you're drilling a new well or buying a property with an old one, here's what the state's records show and what to know.

Simplified drawing of the ground and a typical well Ground around Colbert: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 187 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 187 ft Half of wells 112–265 ft Water fills to ft Water fills to Unknown
A typical well around Colbert It's 187 ft deep, and the blue is the water in it. There aren't enough records here to say how full wells get. Half the wells here are 112 to 265 ft deep, shown by the bracket. Based on state well records.

Well data for Colbert

From 473 water well reports filed with the Washington State Department of Ecology.

Median well depth
187 ft
Half are 112–265 ft deep
Water well reports
473
11 drilled since 2020
Median well yield
20 gpm
Gallons per minute at completion
How deep wells run around Colbert
  • Under 100 ft 17% of wells (78)
  • 100–199 ft 38% of wells (173)
  • 200–299 ft 28% of wells (126)
  • 300–399 ft 10% of wells (45)
  • 400–599 ft 6% of wells (26)
  • 600 ft or more 2% of wells (8)

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Colbert than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (29 reports list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

An Area of Older Wells

The state has 473 water well reports for the area around Colbert. About 62% of the wells with a recorded depth were drilled before 2000, and only 11 reports are for wells drilled since 2020, compared with 114 around Chattaroy a few miles up the valley. The median well around Colbert is 187 feet deep, and the median tested yield is 20 gallons per minute.

Depths Around Colbert

Most of the well reports are west and northwest of town, where the medians are 186 and 175 feet. Southeast of town the median is 157 feet. To the north and northeast, wells run deeper, with medians of 241 and 300 feet, though fewer wells have been drilled there.

The U.S. Geological Survey's study of the Little Spokane River basin describes an upper sand and gravel aquifer averaging about 70 feet thick, over silt and clay layers, deeper sand lenses, basalt and bedrock. Groundwater moves from the higher tributary areas toward the valley floors, following the same pattern as the streams (USGS SIR 2013-5124). With only 19 well reports filed since 2015, the older reports nearby are the best guide to a new well, and we look them up before we quote.

Buying a Property With an Older Well

  • Find the well report. Ecology's Well Report Viewer lets you search by map, or by a partial owner name or address. The report shows how deep the well is, what it was drilled through and what it produced when it was tested.
  • Older wells keep the older rules. Ecology says a well drilled before January 19, 2018 is regulated solely under the standard permit exemption (up to 5,000 gallons a day for household use), and the newer Little Spokane requirements don't apply to it.
  • Test the water. Coliform bacteria and nitrate are the basics, and the Spokane Regional Health District notes that some wells in the county have elevated uranium or arsenic, so those are worth adding.

Rules for a New Well

Colbert is in the Little Spokane watershed (WRIA 55). For a new home on a new permit-exempt well, the state's 2018 streamflow law (RCW 90.94.020) limits indoor and outdoor use combined to an annual average of 3,000 gallons a day, with no more than 5,000 on any day, and Spokane County collects a $500 fee with the building permit (or you can buy a stream flow mitigation certificate instead). For a subdivision, the limit applies to each house.

Before the building permit is issued, the Spokane Regional Health District reviews water adequacy: the well report, a pump test certification showing at least 1,440 gallons per day, and samples taken by an SRHD-approved sampler showing no coliform bacteria and nitrate no higher than 10 mg/L (SRHD water adequacy guide). We file the new well's report with Ecology within 30 days of finishing.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Colbert half of the wells land between 112 and 265 feet. Our guide to the cost of drilling a well covers the rest. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Colbert

How deep are wells around Colbert?
Does the 3,000-gallon limit apply to my existing well?
How do I find the well report for a property I am buying?
How soon can you drill a well near Colbert?