Skip to main content

Water Well Drilling in Davenport, WA

Davenport is the county seat of Lincoln County, about 13 miles west of our base in Reardan. Wells here tend to be shallower than in the rest of the county, with good yields. Here's what the state's records show and what to know before you drill.

Simplified drawing of the ground and a typical well Ground around Davenport: Layers of basalt lava flows. Wells usually find water in the broken rock between them. A typical well reaches 159 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 159 ft Half of wells 104–220 ft Water fills to 40 ft Water fills to Unknown
A typical well around Davenport It's 159 ft deep. Water fills the well up to about 40 ft below the ground (the blue). Half the wells here are 104 to 220 ft deep, shown by the bracket. Based on state well records.

Well data for Davenport

From 258 water well reports filed with the Washington State Department of Ecology.

Median well depth
159 ft
Half are 104–220 ft deep
Water well reports
258
22 drilled since 2020
Median depth to water
40 ft
Static water level at completion
Median well yield
24 gpm
Gallons per minute at completion
How deep wells run around Davenport
  • Under 100 ft 17% of wells (43)
  • 100–199 ft 47% of wells (119)
  • 200–299 ft 22% of wells (55)
  • 300–399 ft 7% of wells (17)
  • 400–599 ft 5% of wells (13)
  • 600 ft or more 2% of wells (5)

Wells drilled since 2015 have a median depth of 140 ft, shallower than the 165 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Davenport than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (39 reports list a water level and 51 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Wells Around Davenport

The state has 258 water well reports for the area around Davenport, and 22 of them are for wells drilled since 2020. The median well is 159 feet deep, well under the Lincoln County median of 233 feet, and half of the wells are between 104 and 220 feet. Water typically settles about 40 feet below the surface, and the median tested yield is 24 gallons per minute, compared with 20 for the county.

North of town the median well is 200 feet deep and to the west 180 feet. South of town, wells are shallower, with a median of 102 feet. Before we give you an estimate, we look up the well reports filed for the properties closest to yours.

Basalt Country

Davenport sits on the Columbia Plateau, where, according to the U.S. Geological Survey, "the primary aquifers within the Columbia Plateau occur in basalts of the Columbia River Basalt Group." Those basalts were laid down as more than 350 separate lava flows, each from 10 to more than 300 feet thick, with layers of sediment in places between them (USGS Fact Sheet 2015-3063). A well's depth and yield depend on where it meets water-bearing zones in that stack, which is why neighboring wells can differ.

Three Watersheds

  • Lower Lake Roosevelt (WRIA 53): about 54% of the well reports, with a median depth of 164 feet. Ecology says groundwater from bedrock here is "very limited by climate and geology" and that "many areas are in decline," and notes the permit exemption "may not be available to prospective water users in certain areas" that have been closed (WRIA 53 summary).
  • Upper Crab-Wilson (WRIA 43): about 25%, with a median of 130 feet. Ecology notes that, because of extensive bedrock, only a fraction of the rain and snow becomes groundwater here (WRIA 43 summary). The Odessa Subarea, where groundwater is declining, is in the far southwest of this watershed, well away from Davenport.
  • Lower Spokane (WRIA 54): about 21%, with a median of 200 feet.

None of the three falls under the 2018 streamflow law's fee and 3,000-gallon limit, so a household well near Davenport can supply up to 5,000 gallons a day, plus watering up to half an acre of lawn or noncommercial garden, without a water right (RCW 90.44.050). Stock watering is also exempt; irrigation beyond the exemption needs a water right before the well is drilled. More on agricultural wells.

What Lincoln County Needs Before You Build

Lincoln County asks for proof of potable water, such as a well log or a letter from a water system, for the septic permit, and a septic permit before it issues a residential building permit (Lincoln County Building Division). Lincoln County Public Health doesn't regulate wells that serve a single home, but it regulates small Group B water systems and offers water testing (Lincoln County Public Health). We file the well report with Ecology within 30 days of finishing, so you'll have the log for the septic permit. How to read a well report.

Testing Your Water

Test a new well for coliform bacteria and nitrate, and repeat the tests regularly; nitrate is worth watching anywhere near farm fields.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Davenport half of the wells land between 104 and 220 feet, shallower than in much of Lincoln County. Our guide to the cost of drilling a well covers the rest. We also drill around Reardan and across Lincoln County. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Davenport

How deep are wells around Davenport?
Is there a $500 fee or 3,000-gallon limit for a new well near Davenport?
What does Lincoln County need from my well before I can build?
How soon can you drill a well near Davenport?