Wells Around Spokane Valley
The state has 872 water well reports for the area around Spokane Valley, but only 26 of them are for wells drilled since 2020. That fits how the valley gets its water: the Department of Ecology notes that "the majority of the region is served by existing municipal water suppliers," so private wells are mostly for properties those suppliers don't reach.
Depths here vary more than almost anywhere else in Spokane County. The median well is 195 feet deep, but half of the wells are between 103 and 400 feet, and one in ten goes deeper than 560 feet.
The Aquifer and the Ground Around It
The U.S. Geological Survey describes the Spokane Valley-Rathdrum Prairie aquifer as "thick layers of coarse-grained sediments" deposited "during a series of outburst floods," in a valley "surrounded by bedrock highlands." It was designated a sole source aquifer by the EPA in 1978 and supplies drinking water for more than 500,000 people (USGS SIR 2007-5041).
The well records show how much location matters. West of the city center, the median well is 90 feet deep. Southwest of the city center, the median is 400 feet, water typically settles about 140 feet below the surface, and the median tested yield is just 6 gallons per minute. That's also where most of the recent drilling has been: 33 of the 67 well reports filed since 2015 are southwest of the city center, and those wells have a median depth of 520 feet.
Can You Drill a Well in Spokane Valley?
Since February 27, 2015, a state rule for the Spokane River and the aquifer (WAC 173-557) has covered every new use of its water. Ecology's guide to permit-exempt wells over the aquifer (publication 15-11-011) lays out how it works:
- It starts with the building permit. The building department checks whether your parcel is inside the aquifer boundary and tells you your water supply options.
- Ask the water supplier first. If a public water supplier serves your area and can provide water "in a reasonable and timely manner," you connect, and the rule doesn't affect you.
- If it can't, or there's no supplier, request mitigation water. A letter to Ecology's Eastern Region office explains why (the supplier should write it if possible) and includes your parcel details and the well log if you have one. If the SVRP Aquifer Bank has water and the use fits, Ecology issues a release letter that reserves water for your project for up to three years. The bank covers permit-exempt uses of a single home free of charge.
- Get the certificate before move-in. Before the building department issues a certificate of occupancy, you request a Certificate of Mitigation from Ecology, which is recorded with the County Auditor for a recording fee. No flow meter is currently required.
The north end of the area is different again: about 15% of the well reports around Spokane Valley are in the Little Spokane watershed, where the state's 2018 streamflow law limits a new home's domestic use to an annual average of 3,000 gallons a day and Spokane County collects a $500 fee with the building permit (RCW 90.94.020). The county confirms which rules apply to your parcel on its building permits and water supply page.
Building Permit Water Requirements
Once the well is in, the Spokane Regional Health District reviews water adequacy before the building permit is issued: the well report, a pump test certification showing at least 1,440 gallons per day, and samples taken by an SRHD-approved sampler showing no coliform bacteria and nitrate no higher than 10 mg/L (SRHD water adequacy guide). We file the well report with Ecology within 30 days of finishing.
Testing Your Water
Beyond the coliform and nitrate tests the permit requires, the health district notes that some wells in Spokane County have elevated uranium or arsenic, and the state Department of Health lists the county among those with elevated uranium in some groundwater. Testing for both once the well is in service is a good idea.
Planning Your Budget
Depth is the biggest factor in what a well costs, and in Spokane Valley it can range from around 90 feet to well past 400. Our guide to the cost of drilling a well covers the rest. Spokane Valley is about 30 miles from our base in Reardan, and nearby we also drill around Spokane and Mead. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.