Skip to main content

Water Well Drilling in Newman Lake, WA

Newman Lake sits northeast of Spokane Valley near the Idaho line, about 37 miles from our base in Reardan. Wells here run deep and produce less water than anywhere else in Spokane County, and the valley aquifer reaches only the south end of the lake. Here's what the state's records show and what to know before you drill.

Simplified drawing of the ground and a typical well Ground around Newman Lake: The ground changes across the area: sediment in some places, rock close to the surface in others. A typical well reaches 360 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 360 ft Half of wells 260–500 ft Water fills to 95 ft Water fills to Unknown
A typical well around Newman Lake It's 360 ft deep. Water fills the well up to about 95 ft below the ground (the blue). Half the wells here are 260 to 500 ft deep, shown by the bracket. Based on state well records.

Well data for Newman Lake

From 567 water well reports filed with the Washington State Department of Ecology.

Median well depth
360 ft
Half are 260–500 ft deep
Water well reports
567
43 drilled since 2020
Median depth to water
95 ft
Static water level at completion
Median well yield
6 gpm
Gallons per minute at completion
How deep wells run around Newman Lake
  • Under 100 ft 2% of wells (12)
  • 100–199 ft 10% of wells (56)
  • 200–299 ft 19% of wells (102)
  • 300–399 ft 25% of wells (137)
  • 400–599 ft 36% of wells (197)
  • 600 ft or more 8% of wells (46)

Wells drilled since 2015 have a median depth of 420 ft, deeper than the 325 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Newman Lake than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (87 reports list a water level and 105 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Deep Wells, Modest Yields

The state has 567 water well reports for the area around Newman Lake, and 43 of them are for wells drilled since 2020. The median well is 360 feet deep, one of the deepest medians in Spokane County, where the county as a whole is 200 feet. Half of the wells are between 260 and 500 feet, and water typically settles about 95 feet below the surface.

What stands out is the yield. The median tested yield is 6 gallons per minute, the lowest of any Spokane County community we track, against 13 for the county. That's one reason we look at the well reports nearest your property before we drill, and why the pump test at the end matters.

Similar Depths All Around the Lake

In some areas, depth depends on which side of town you're on. Around Newman Lake it doesn't change much: in every direction from the lake, the median well is between 300 and 400 feet deep. New wells are going in all around the lake, too, with no single direction accounting for more than 16 of the 77 reports filed since 2015. Individual wells still vary, so the nearest reports are the best guide.

At the Edge of the Valley Aquifer

The U.S. Geological Survey describes the Spokane Valley-Rathdrum Prairie aquifer as "bounded laterally by bedrock" and lists Newman Lake among the lakes along its margins (USGS SIR 2005-5227). Its map of the aquifer shows a narrow arm reaching north from the valley floor near Otis Orchards and ending at the lake's south end. The land around the rest of the lake is outside it.

That line matters for permits. The state's rule for the aquifer (WAC 173-557) covers groundwater within its boundary, and "hydrologic evidence of the SVRP aquifer determines applicability." Inside it, a water supplier that can serve you is the first choice, and if none can, a permit-exempt well needs mitigation, which Ecology's SVRP Aquifer Bank provides free for a single home. Our Spokane Valley page walks through the steps.

Water Rules Around the Lake

  • Middle Spokane watershed: about 91% of the well reports. Outside the aquifer, a household well can supply up to 5,000 gallons a day, plus watering up to half an acre of lawn or noncommercial garden, without a water right (RCW 90.44.050).
  • Little Spokane watershed: about 9% of the well reports. Here the 2018 streamflow law limits a new home to an annual average of 3,000 gallons a day, and Spokane County collects a $500 fee with the building permit (RCW 90.94.020).
  • The lake and its creeks: taking water from the lake needs a water right, since there's no permit exemption for surface water, and Thompson Creek, which feeds the lake, is closed to new uses (Ecology's WRIA 57 summary).

Building Permit Water Requirements

Before a building permit is issued for a home on a private well in Spokane County, the Spokane Regional Health District reviews water adequacy: the well report, a pump test certification showing at least 1,440 gallons per day, which is one gallon per minute, and samples taken by an SRHD-approved sampler showing no coliform bacteria and nitrate no higher than 10 mg/L (SRHD water adequacy guide). We file the well report with Ecology within 30 days of finishing.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Newman Lake half of the wells land between 260 and 500 feet. Our guide to the cost of drilling a well covers the rest. We also drill around Otis Orchards, about 5 miles away. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Newman Lake

How deep are wells around Newman Lake, and how much water do they produce?
Is Newman Lake over the Spokane Valley aquifer?
Can I take water from the lake instead of drilling a well?
How soon can you drill a well near Newman Lake?