Wells Around Nine Mile Falls
The state has 850 water well reports for the area around Nine Mile Falls, and 53 of them are for wells drilled since 2020. The median well is 200 feet deep, and water levels run deep: the median depth to water, the level it settles at once the well is drilled, is 145 feet, one of the deepest of the Spokane County communities we track. The median tested yield is 15 gallons per minute.
Two Watersheds, Different Depths
About 83% of the well reports are in the Lower Spokane watershed (WRIA 54), where the median well is 154 feet deep, and about 18% are in the Little Spokane watershed (WRIA 55), where it's 260 feet. By direction, the median is 195 feet west of town, 220 feet to the southwest, 268 feet to the south and 253 feet to the east.
Newer wells have gone deeper, and most of the recent drilling has been to the southwest and west: 68 of the 113 reports filed since 2015. Southwest of town, water typically settles about 176 feet below the surface. Before we give you an estimate, we look up the well reports filed for the properties closest to yours.
Three Sets of Water Rules
- Lower Spokane watershed. Outside the aquifer, the standard permit exemption applies: up to 5,000 gallons a day for household use, plus watering up to half an acre of lawn or noncommercial garden, without a water right permit (RCW 90.44.050), and no streamflow fee.
- Little Spokane watershed. For a new home on a new permit-exempt well, the state's 2018 streamflow law limits indoor and outdoor use combined to an annual average of 3,000 gallons a day, and Spokane County collects a $500 fee with the building permit (RCW 90.94.020). Wells drilled before January 19, 2018 aren't affected.
- The aquifer. The U.S. Geological Survey describes the Spokane Valley-Rathdrum Prairie aquifer as extending west from Idaho "to near Nine Mile Falls northwest of Spokane" (USGS SIR 2007-5041). New use of aquifer water falls under the state's 2015 rule (WAC 173-557): water suppliers are the first choice, and if one can't serve your parcel in a timely and reasonable way, a permit-exempt well needs mitigation, which Ecology's SVRP Aquifer Bank provides free of charge for a single home (Ecology publication 15-11-011).
You don't have to work this out alone: the building department checks whether your parcel is inside the aquifer boundary when you apply for a permit, and Spokane County's building permits and water supply page covers the options.
Building Permit Water Requirements
Before a building permit is issued for a home on a private well in Spokane County, the Spokane Regional Health District reviews water adequacy: the well report, a pump test certification showing at least 1,440 gallons per day, and samples taken by an SRHD-approved sampler showing no coliform bacteria and nitrate no higher than 10 mg/L (SRHD water adequacy guide). We file the well report with Ecology within 30 days of finishing. How to read a well report.
Testing Your Water
Start with the coliform and nitrate tests the permit requires, and consider uranium and arsenic, which the health district notes are elevated in some Spokane County wells. Ecology's West Plains PFAS drilling advisory names Deep Creek as the northern boundary of the area of known and suspected contamination, so if your property is south of Deep Creek, toward Airway Heights, add a PFAS test with EPA Method 533 at an accredited lab (Ecology's advisory).
Planning Your Budget
Depth is the biggest factor in what a well costs, and around Nine Mile Falls half of the wells land between 100 and 296 feet. Deep water levels also mean a deeper pump setting, which adds to the cost of the pump system. Our guide to the cost of drilling a well covers the rest. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.