Skip to main content

Water Well Drilling in Stevens County, WA

Stevens County runs from the Spokane County line to the Canadian border, along the Colville River valley and Lake Roosevelt. Here's what the state's well records show about drilling there, and what the county asks for before you build.

Simplified drawing of the ground and a typical well Ground in Stevens County: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 194 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 194 ft Half of wells 100–317 ft Water fills to 60 ft Water fills to Unknown
A typical well in Stevens County It's 194 ft deep. Water fills the well up to about 60 ft below the ground (the blue). Half the wells here are 100 to 317 ft deep, shown by the bracket. Based on state well records.

Well data for Stevens County

From 11,768 water well reports filed with the Washington State Department of Ecology.

Median well depth
194 ft
Half are 100–317 ft deep
Water well reports
11,768
1,092 drilled since 2020
Median depth to water
60 ft
Static water level at completion
Median well yield
7 gpm
Gallons per minute at completion
How deep wells run around Stevens County
  • Under 100 ft 24% of wells (2,653)
  • 100–199 ft 27% of wells (3,067)
  • 200–299 ft 18% of wells (2,037)
  • 300–399 ft 14% of wells (1,575)
  • 400–599 ft 13% of wells (1,446)
  • 600 ft or more 4% of wells (488)

Wells drilled since 2015 have a median depth of 239 ft, deeper than the 170 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Depths, water levels and yields are as the drillers reported them (1,709 reports list a water level and 2,034 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Well Drilling Across Stevens County

The state has 11,768 water well reports for Stevens County, and 1,092 of them are for wells drilled since 2020. The median depth is 194 feet, close to Spokane County's, but yields are lower: the median tested yield is 7 gallons per minute, compared with 13 in Spokane County and 20 in Lincoln County. By community, medians run from 130 feet around Ford to 270 around Hunters.

Valleys and Bedrock

In its study of the Colville River watershed, the U.S. Geological Survey found glacial and alluvial deposits in the valleys that are more than 700 feet thick in places, with an upper outwash aquifer that is "discontinuous but is a productive and widely used source." In most of the watershed, though, "bedrock is present at or near land surface, and is the only source of ground water for landowners who live in those areas," and bedrock "typically has very low permeabilities, except where it is fractured" (USGS SIR 2004-5237).

In practice, that means two neighboring properties can have very different wells: one on the valley floor may find water in sand and gravel, while one on a hillside depends on finding fractures in the rock. It's also why we look at the well reports filed nearby before we quote.

Water Rules by Watershed

Stevens County spans several watersheds, and the rules for a new well depend on which one your property is in:

  • Colville and Little Spokane watersheds (most of the area around Colville, Chewelah, Kettle Falls, Loon Lake and Clayton): under RCW 90.94.020, a new home's domestic use is limited to 3,000 gallons a day, and the county collects a $500 fee with the building permit. Ecology also describes the Colville's tributaries as "generally closed to new water uses" and the Colville River as closed from July 16 to September 30 (Ecology WRIA 59 summary).
  • Lake Roosevelt watersheds (around Northport and Hunters): Ecology's summaries note the permit exemption "may not be available to prospective water users in certain areas," so it's worth checking with Ecology's Eastern Region office for a specific property.
  • Lower Spokane watershed (most of the area around Springdale, Tumtum and Ford): the standard permit exemption applies, up to 5,000 gallons a day for household use.

Watershed lines don't follow town lines (the areas around Springdale and Tumtum each straddle two), so the county confirms which rule applies to your parcel when you apply for the building permit.

Building Permit Water Requirements

Stevens County Land Services' guide to potable water requirements asks for:

  • Quantity: at least 800 gallons a day (about 0.56 gallons per minute) for a single home, or 1,600 for two, held over four hours. A well log, a pump test by a licensed driller or pump installer, or an owner's pump test on the county's form can show it.
  • Quality: no coliform bacteria; nitrate 10 mg/L or less; arsenic 0.01 mg/L or less; lead 0.015 mg/L or less; uranium 30 µg/L or less. Results must come from a state-certified lab and be less than two years old.
  • If a well falls short: the county can approve a storage system for low quantity, or treatment with a recorded notice for water quality.

The guide dates from 2018, so confirm the current requirements with Land Services when you apply.

Testing Your Water

The Northeast Tri-County Health District recommends testing every year for coliform bacteria and nitrate, testing for uranium every three to five years, and testing for arsenic twice, once in summer and once in winter. It notes that uranium "is especially common throughout Ferry, Stevens and Pend Oreille Counties" (NETCHD drinking water wells).

Communities in Stevens County

Typical well depths around each community we drill in, with the most well reports first.

Community Median depth Depth to water
Colville 171 ft 50 ft
Clayton 160 ft 35 ft
Springdale 149 ft 71 ft
Tumtum 220 ft 70 ft
Northport 180 ft 65 ft
Valley 180 ft 64 ft
Chewelah 180 ft 74 ft
Loon Lake 198 ft 103 ft
Kettle Falls 245 ft 70 ft
Ford 130 ft 52 ft
Addy 200 ft 43 ft
Hunters 270 ft Too few reports

Questions about well drilling in Stevens County

How deep are wells in Stevens County?
What does Stevens County need to see from a new well before I can build?
Is uranium a concern in Stevens County wells?
Are there water limits on new wells in the Colville valley?