Skip to main content

Water Well Drilling in Chewelah, WA

Chewelah sits in the Colville River valley in south-central Stevens County, about 43 miles from our base in Reardan. Newer wells here go deeper than older ones by more than anywhere else in the county. Here's what the state's records show and what to know before you drill.

Simplified drawing of the ground and a typical well Ground around Chewelah: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 180 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 180 ft Half of wells 93–300 ft Water fills to 74 ft Water fills to Unknown
A typical well around Chewelah It's 180 ft deep. Water fills the well up to about 74 ft below the ground (the blue). Half the wells here are 93 to 300 ft deep, shown by the bracket. Based on state well records.

Well data for Chewelah

From 559 water well reports filed with the Washington State Department of Ecology.

Median well depth
180 ft
Half are 93–300 ft deep
Water well reports
559
46 drilled since 2020
Median depth to water
74 ft
Static water level at completion
Median well yield
10 gpm
Gallons per minute at completion
How deep wells run around Chewelah
  • Under 100 ft 28% of wells (151)
  • 100–199 ft 25% of wells (135)
  • 200–299 ft 19% of wells (101)
  • 300–399 ft 15% of wells (81)
  • 400–599 ft 10% of wells (54)
  • 600 ft or more 3% of wells (14)

Wells drilled since 2015 have a median depth of 250 ft, deeper than the 140 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Chewelah than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (66 reports list a water level and 77 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Wells Around Chewelah

The state has 559 water well reports for the area around Chewelah, and 46 of them are for wells drilled since 2020. The median well is 180 feet deep, half of the wells are between 93 and 300 feet, water typically settles about 74 feet below the surface, and the median tested yield is 10 gallons per minute.

Newer Wells Are Going Deeper

Wells drilled since 2015 have a median depth of 250 feet, compared with 140 feet for wells drilled before 2000, the biggest change of any Stevens County community we track. Much of that is about where people are drilling now: 38 of the 83 reports filed since 2015 are north of town, where recent wells have a median of 240 feet and water typically settles about 75 feet down.

Elsewhere the picture is different. West and northwest of town, the medians are 100 and 120 feet; to the east and southwest, 231 and 216 feet. Before we give you an estimate, we look up the well reports filed for the properties closest to yours.

Under the Colville Valley

The U.S. Geological Survey's study of the Colville River watershed describes a thick layer of lake-bed clay and silt running the length of the valley floor, including the valley of the South Fork of Chewelah Creek, with an average thickness of about 150 feet. Below it is a lower sand and gravel aquifer that is confined in most places, and on much of the valley floor many wells completed in it flow at the land surface. Away from the valley, bedrock is at or near the surface in most of the watershed, with very low permeability except where it's fractured (USGS SIR 2004-5237).

Water Rules

Chewelah is in the Colville River watershed (WRIA 59). For a new home on a new permit-exempt well, the state's 2018 streamflow law limits indoor and outdoor use combined to an annual average of 3,000 gallons a day, with no more than 5,000 on any day, and the county collects a $500 fee with the building permit (RCW 90.94.020). Ecology describes the Colville's tributaries, Chewelah Creek among them, as "generally closed to new water uses," so water for larger uses like irrigation is hard to come by (Ecology's WRIA 59 summary).

What Stevens County Needs Before You Build

Stevens County Land Services' guide to potable water requirements asks for at least 800 gallons a day for a single home, held over four hours, and lab results from a state-certified lab, less than two years old, showing no coliform bacteria and nitrate, arsenic, lead and uranium within limits. The county can approve storage if a well is short on quantity, or treatment with a recorded notice if it's short on quality. Confirm the current requirements with Land Services when you apply.

A Testing Schedule That Fits the Area

The Northeast Tri-County Health District recommends (NETCHD drinking water wells):

  • Every year: coliform bacteria and nitrate. If nitrate is 5 mg/L or higher, re-test in six months.
  • Every three to five years: uranium, which it says "is especially common throughout Ferry, Stevens and Pend Oreille Counties." Levels vary by season, so test in summer, April through September.
  • At least twice while you own the well: arsenic, once in summer and once in winter.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Chewelah the median runs from 100 feet west of town to 240 feet for recent wells to the north. Our guide to the cost of drilling a well covers the rest. We also drill around Colville and Springdale. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Chewelah

How deep are wells around Chewelah?
Why are newer wells around Chewelah so much deeper?
When should I test a new well near Chewelah for uranium?
How soon can you drill a well near Chewelah?