Skip to main content

Water Well Drilling in Sprague, WA

Sprague sits on Interstate 90 in southeastern Lincoln County, about 26 miles from our base in Reardan. Household wells here are fairly shallow by Lincoln County standards, though the record is small and depths vary. Here's what the state's records show and what to know before you drill.

Simplified drawing of the ground and a typical well Ground around Sprague: Layers of basalt lava flows. Wells usually find water in the broken rock between them. A typical well reaches 160 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 160 ft Half of wells 98–247 ft Water fills to ft Water fills to Unknown
A typical well around Sprague It's 160 ft deep, and the blue is the water in it. There aren't enough records here to say how full wells get. Half the wells here are 98 to 247 ft deep, shown by the bracket. Based on state well records.

Well data for Sprague

From 116 water well reports filed with the Washington State Department of Ecology.

Median well depth
160 ft
Half are 98–247 ft deep
Water well reports
116
8 drilled since 2020
How deep wells run around Sprague
  • Under 100 ft 26% of wells (30)
  • 100–199 ft 41% of wells (48)
  • 200–299 ft 14% of wells (16)
  • 300–399 ft 11% of wells (13)
  • 400–599 ft 6% of wells (7)
  • 600 ft or more 2% of wells (2)

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Sprague than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them. Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Wells Around Sprague

The state has 116 water well reports for the area around Sprague, 22 of them filed since 2015. The median well is 160 feet deep, compared with 233 feet for Lincoln County, and half of the wells are between 98 and 247 feet. One in ten goes past 374 feet. Too few of the reports list a water level or a pump test to give a reliable median for either.

Household Wells and Larger Wells

Most of the reports, 90 of 116, are for wells 6 inches across or less, the usual size for a home, and their median depth is 140 feet. The 26 wider wells, which are more often farm or public supply wells, have a median of 300 feet. For a house, the household-size wells are the better guide, and the reports filed for the properties nearest yours are better still. We look them up before we give you an estimate.

Palouse Water Rules

About 79% of the well reports around Sprague are in the Palouse watershed (WRIA 34), and the rest in the Upper Crab-Wilson watershed (WRIA 43). Neither is covered by the 2018 streamflow law's fee and 3,000-gallon limit, so a household well can supply up to 5,000 gallons a day, plus watering up to half an acre of lawn or noncommercial garden, without a water right (RCW 90.44.050). Stock watering is exempt too.

Water for larger uses is hard to come by. Ecology says that because of extensive bedrock, "only a small fraction" of the Palouse watershed's precipitation becomes groundwater, and that the Sprague Lake and Cow Creek subbasins have been adjudicated, which indicates "most, if not all, of the available water has already been allocated" (Ecology's WRIA 34 summary). The Odessa Subarea, where new groundwater rights aren't available, lies several miles to the west (WAC 173-128A-040). More on agricultural wells and water rights.

What You'll Need for a Building Permit

Most of the area is in Lincoln County, where the septic permit requires proof of potable water, such as the well log, and comes before the residential building permit (Lincoln County's building requirements). Lincoln County Public Health offers water testing (LCPH). Some of the well reports grouped with Sprague are across the line in Spokane County, where the health district instead asks for a pump test showing at least 1,440 gallons per day plus coliform and nitrate samples (SRHD). We file the well report with Ecology within 30 days of finishing.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Sprague household-size wells have a median of 140 feet. Our guide to the cost of drilling a well covers the rest. We also drill around Edwall and Harrington. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Sprague

How deep are wells around Sprague?
Is Sprague in the Odessa Subarea?
Can I get water from Sprague Lake?
How soon can you drill a well near Sprague?