Skip to main content

Water Well Drilling in Loon Lake, WA

Loon Lake sits in southern Stevens County, about 29 miles from our base in Reardan, around the lake it's named for. Water levels in the wells here run deeper than anywhere else in the county. Here's what the state's records show and what to know before you drill.

Simplified drawing of the ground and a typical well Ground around Loon Lake: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 198 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 198 ft Half of wells 120–320 ft Water fills to 103 ft Water fills to Unknown
A typical well around Loon Lake It's 198 ft deep. Water fills the well up to about 103 ft below the ground (the blue). Half the wells here are 120 to 320 ft deep, shown by the bracket. Based on state well records.

Well data for Loon Lake

From 524 water well reports filed with the Washington State Department of Ecology.

Median well depth
198 ft
Half are 120–320 ft deep
Water well reports
524
83 drilled since 2020
Median depth to water
103 ft
Static water level at completion
Median well yield
7 gpm
Gallons per minute at completion
How deep wells run around Loon Lake
  • Under 100 ft 17% of wells (88)
  • 100–199 ft 33% of wells (169)
  • 200–299 ft 17% of wells (88)
  • 300–399 ft 13% of wells (68)
  • 400–599 ft 14% of wells (69)
  • 600 ft or more 5% of wells (23)

Wells drilled since 2015 have a median depth of 274 ft, deeper than the 165 ft median for wells drilled before 2000.

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Loon Lake than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them (109 reports list a water level and 126 list a yield). Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

Wells Around Loon Lake

The state has 524 water well reports for the area around Loon Lake, and 83 of them are for wells drilled since 2020. The median well is 198 feet deep and half of the wells are between 120 and 320 feet. Living next to a lake doesn't mean shallow water: the median depth to water, the level it settles at once the well is drilled, is 103 feet, the deepest of any Stevens County community we track. The median tested yield is 7 gallons per minute.

Where the New Wells Are

Much of the recent drilling has been north of town: 53 of the 125 well reports filed since 2015. Wells there have a median depth of 180 feet, and water typically settles about 135 feet down. To the east the median is 300 feet, to the west 225 feet, and to the northwest 118 feet. Before we give you an estimate, we look up the well reports filed for the properties closest to yours.

Two Watersheds, One Rule

About 84% of the well reports around Loon Lake are in the Colville River watershed (WRIA 59), with a median depth of 178 feet, and about 16% are in the Little Spokane watershed (WRIA 55), with a median of 300 feet. Both are covered by the same part of the state's 2018 streamflow law (RCW 90.94.020): a new home on a new permit-exempt well is limited to an annual average of 3,000 gallons a day, with no more than 5,000 on any day, and the county collects a $500 fee with the building permit. Wells drilled before January 19, 2018 aren't affected.

The Lake and the Water Table

The U.S. Geological Survey's study of the Colville River watershed notes that the levels of the larger lakes, including Loon, Deer, Jumpoff Joe and Waitts, likely rise and fall with the water table. It also describes the dunes north of Loon Lake as a record of floodwaters that drained west through the Sheep Creek spillway (USGS SIR 2004-5237).

Ecology's rule for the watershed closes Loon Lake to new appropriations, and groundwater appropriations are subject to the same conditions. The 2018 streamflow law is what allows new homes on permit-exempt wells here, and the watershed plan Ecology adopted in 2020 includes projects to offset their water use (Ecology's WRIA 59 summary).

What Stevens County Needs Before You Build

Stevens County Land Services' guide to potable water requirements asks for at least 800 gallons a day for a single home, held over four hours, and lab results less than two years old from a state-certified lab showing no coliform bacteria and nitrate, arsenic, lead and uranium within limits. The county can approve storage if a well is short on quantity, or treatment with a recorded notice if it's short on quality. Confirm the current requirements with Land Services when you apply.

Testing Your Water

The Northeast Tri-County Health District recommends testing every year for coliform bacteria and nitrate, every three to five years for uranium, which it says "is especially common throughout Ferry, Stevens and Pend Oreille Counties," and at least twice for arsenic, once in summer and once in winter (NETCHD). If a test turns something up, we're happy to recommend local water treatment professionals.

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Loon Lake half of the wells land between 120 and 320 feet. A deep water level also means a deeper pump setting, which adds to the cost of the pump system. Our guide to the cost of drilling a well covers the rest. We also drill around Clayton and Springdale. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Loon Lake

How deep are wells around Loon Lake?
Can I draw water from Loon Lake instead of drilling a well?
What water tests will I need when buying or selling a place with a well?
How soon can you drill a well near Loon Lake?