Skip to main content

Water Well Drilling in Hunters, WA

Hunters sits near Lake Roosevelt on the west side of Stevens County, about 34 miles north of our base in Reardan. Far fewer well reports have been filed here than around the valley towns, and the wells on record run deep and vary widely. Here's what the state's records show and what to know before you drill.

Simplified drawing of the ground and a typical well Ground around Hunters: Glacial sand, gravel and clay in the valleys, with bedrock below and on the higher ground. A typical well reaches 270 feet. Surface 100 ft 200 ft 300 ft 400 ft 500 ft Typical well 270 ft Half of wells 140–400 ft Water fills to ft Water fills to Unknown
A typical well around Hunters It's 270 ft deep, and the blue is the water in it. There aren't enough records here to say how full wells get. Half the wells here are 140 to 400 ft deep, shown by the bracket. Based on state well records.

Well data for Hunters

From 64 water well reports filed with the Washington State Department of Ecology.

Median well depth
270 ft
Half are 140–400 ft deep
Water well reports
64
7 drilled since 2020
How deep wells run around Hunters
  • Under 100 ft 15% of wells (9)
  • 100–199 ft 26% of wells (16)
  • 200–299 ft 11% of wells (7)
  • 300–399 ft 21% of wells (13)
  • 400–599 ft 21% of wells (13)
  • 600 ft or more 6% of wells (4)

Source: Washington State Department of Ecology well reports, records through February 2025. Counts wells closer to Hunters than to any other community we track, within 10 miles. Depths, water levels and yields are as the drillers reported them. Report locations are accurate to about 40 acres. These figures describe the area, not your property: we check the reports nearest your site before we quote.

A Small Record With a Wide Range

The state has 64 water well reports for the area around Hunters, 12 of them filed since 2015. The median well is 270 feet deep, the deepest of any Stevens County community we track and well above the county median of 194 feet. Half of the wells are between 140 and 400 feet, and one in ten goes past 540 feet.

The spread is the real story. About 40% of the wells are less than 200 feet deep, while about 48% go deeper than 300 feet. Too few of the reports list a water level or a pump test to give a reliable median for either, so for a property near Hunters, the specific reports filed nearby, and sometimes a wider look at the surrounding area, are the best guide. We do that research before we give you an estimate.

The Middle Lake Roosevelt Watershed

Hunters is in the Middle Lake Roosevelt watershed (WRIA 58), which drains to the lake between the mouths of the Colville and Spokane Rivers. It isn't covered by the 2018 streamflow law's $500 fee and 3,000-gallon limit, so the standard permit exemption lets a household well supply up to 5,000 gallons a day, plus watering up to half an acre of lawn or noncommercial garden, without a water right (RCW 90.44.050). Ecology cautions that the exemption may not be available in areas that have been closed because little or no water is available.

Ecology's summary describes a dry watershed: precipitation ranges from 10 inches a year near the mouth of the Spokane River to 30 inches at higher elevations, and the availability of groundwater from bedrock is "very limited by climate and geology." It lists nine adjudicated tributary basins, Alder Creek among them, and says prior adjudications indicate "most, if not all, of the available water has already been allocated." For larger uses, it notes that water for new appropriations may be possible from Ecology's Lake Roosevelt projects (Ecology's WRIA 58 summary).

Springs and the Lake

The permit exemption covers wells, not surface water. Ecology says plainly that there's no exemption for surface water diversions, and that "this includes development of springs for any purpose." Developing a spring or drawing from Lake Roosevelt for a home needs a water right, so for a home a permit-exempt well is the simpler route.

What Stevens County Needs Before You Build

For a building permit, Stevens County Land Services' guide to potable water requirements asks for a well that produces at least 800 gallons a day for a single home, held over four hours, and results less than two years old from a state-certified lab showing no coliform bacteria and nitrate, arsenic, lead and uranium within limits. A well that's short on quantity can be approved with storage. The Northeast Tri-County Health District recommends re-testing for uranium every three to five years (NETCHD).

Planning Your Budget

Depth is the biggest factor in what a well costs, and around Hunters half of the wells land between 140 and 400 feet, so the nearby reports matter a lot for a realistic number. Our guide to the cost of drilling a well covers the rest. To the southeast, we also drill around Ford and Springdale. For a number specific to your property, send us the address or parcel number, and we'll check the nearby well reports and give you a free estimate.

Questions about well drilling around Hunters

How deep are wells around Hunters?
Can I develop a spring instead of drilling a well?
Is there a $500 fee for a new well near Hunters?
How soon can you drill a well near Hunters?